We have always been committed to the development and application of new products, new technologies, and new processes. In specific work practices, we are constantly reforming and innovating, focusing on enhancing the rationality and practicality of equipment assembly. Recently, in the assembly technology of the roll forming machine, we have summarized several improvements in practice:
The original roll forming machine is driven in series, and all chains are sequentially driven. Its characteristic is that the hanging chain is convenient and easy to operate. However, there are many drawbacks. For example, the bearing capacity of the secondary active chain is too large, and it is easy to break the chain when the machine is running at full load. The link chain between the upper and lower layers is easy to wear due to the limitation of the design angle and wears the chain. In view of this, our improvement measure is to change the upper and lower layers of the roll forming machine into a parallel transmission method. The upper and lower layers are respectively set up with active chains, all of which are directly driven by the motor. Effectively decompose the load bearing pressure of the secondary active chain, and at the same time, there will be no ambiguous phenomenon of the upper and lower link chains.
As long as traditional double-decker devices work, they mostly operate together. However, the upper and lower devices cannot be pressed at the same time. Only one type can be used. Another type of equipment wastes power while running and wears out equipment. In order to solve this problem, some manufacturers use dual motors as the upper and lower levels of power, but this undoubtedly increases the cost of equipment and increases the customer's investment. Through investigations and explorations, we have quoted the current clutch settings to control the operation of the upper and lower layers of the equipment, which layer is used to operate which layer and the other layer is stationary. Under the premise of not adding much cost, it effectively solved this problem.
Dust cover configuration. The double-layer shaft head adopts the dust cover configuration, which effectively prevents dust and sand, enhances safety protection, and is more suitable for outdoor operations. Furthermore, we produce a wide variety of K Span Roll Forming Machine products, such as our K type arch span Forming Machine, including arch K Span Forming Machine, Steel Building Machine, and no-girder automatic building machines, special metal forming equipment, and auxiliary equipment and products. Additionally, we offer OEM services.
Welcome to our website:https://www.kspan-ubm.com/