Ceramic capacitors News
Ceramic capacitors are suitable for moderately high-frequency work (into the high hundreds of megahertz range, or, with great care, into the low gigahertz range), as modern ceramic caps are fairly non-inductive compared to the other major classes of capacitors (film and electrolytic). Capacitor technologies with higher self-resonant frequencies tend to be expensive and esoteric (typically, mica or glass capacitors).
Class I capacitors: accurate, temperature-compensating capacitors. They are the most stable over voltage, temperature, and to some extent, frequency. They also have the lowest losses. On the other hand, they have the lowest volumetric efficiency. A typical class I capacitor will have a temperature coefficient of 30ppm/C. This will typically be fairly linear with temperature. These also allow for high Q filters — a typical class I capacitor will have a dissipation factor of 0.15%. Very high accuracy (~1%) class I capacitors are available (typical ones will be 5% or 10%). The highest accuracy class 1 capacitors are designated C0G or NP0
Class II capacitors: better volumetric efficiency, but lower accuracy and stability. A typical class II capacitor may change capacitance by 15% over a -55C to 85C temperature range. A typical class II capacitor will have a dissipation factor of 2.5%. It will have average to poor accuracy (from 10% down to +20/-80%).
Class III capacitors: high volumetric efficiency, but poor accuracy and stability. A typical class III capacitor will change capacitance by -22% to +56% over a temperature range of 10C-55C. It will have a dissipation factor of 4%. It will have fairly poor accuracy (commonly, 20%, or +80/-20%). These are typically used as decoupling or in other power supply applications.
At one point, Class IV capacitors were also available, with worse electrical characteristics than Class III, but even better volumetric efficiency. They are now rather rare and considered obsolete, as modern multilayer ceramics can offer better performance in a compact package.
These correspond roughly to low K, medium K, and high K. Note that none of the classes are “better” than any others — the relative performance depends on application. Class I capacitors are physically larger than class III capacitors, and for bypassing and other non-filtering applications, the accuracy, stability, and loss factor may be unimportant, while cost and volumetric efficiency may be. As such, Class I capacitors are primarily used in filtering applications, where the main competition is from film capacitors in low frequency applications, and more esoteric capacitors in RF applications. Class III capacitors are typically used in power supply applications. Traditionally, they had no competition in this niche, as they were limited to small sizes. As ceramic technology has improved, ceramic capacitors are now commonly available in values of up to 100uF, and they are increasingly starting to compete with electrolytic capacitors, where ceramics offer much better electrical performance at prices that, while still much higher than electrolytic, are becoming increasingly reasonable as the technology improves.
